Extron electronic MPX Plus 866 A manual Example 6 Setting the RGB delay for an output

PRELIMINARY

Operation, cont’d

Example 6: Setting the RGB delay for an output

In the following example, the RGB delay is increased for ties to output 1. The steps show the front panel indications that result from your action.

1. Clear all selections: Press and release the Esc button.

Press and release the Esc button.

C O N T R O L

ENTER PRESET VIEW ESC

The button flashes once.

2. Select Video mode: Press and hold the Video button for approximately 2 seconds.

Press and hold the Video button until it blinks.

VIDEO 2 seconds VIDEO

Release the button.

3. Select an input: Press and release the output 1 button.

NAn output from the low resolution video group cannot be selected.

	The input buttons 1 through 10 display the selected output's RGB delay.
Press and release the	Each lit input button indicates half a second of delay.
	In this example, the green input buttons display 3.5 seconds of RGB delay.
Output 1 button.
The button lights green.	0.5	1.0	1.5	2.0	2.5	3.0	3.5
				COMPUTER INPUTS			VIDEO INPUTS

1	2	3	4	1	2	3	4	5	6	7	8	9	10 11 12 13 14
	COMPUTER/AUDIO O

NThe RGB delay is protected when front panel lock mode 2 is selected. You can view the delay in lock mode 2, but not change it from the front panel. See “Setting the front panel Locks (Executive modes)” on page 3-44.

If front panel lock mode 2 is selected and you try to perform steps 4, the actions are ignored and the Enter, Video, and Audio buttons flash.

3-24 MPX Plus 866 A Media Presentation Matrix Switcher • Operation