Fagor America SHA-730 X manual Self Help Operation

		Self Help - Operation
Before calling for service, check the following:
Table 9: Self Help - Operation
	Oven Problem	Problem Solving Steps
	F03 or F04 Error appear in the	A problem with the lock occured. Turn power off and turn it back on again
	display window.	after a few seconds. The oven should run a latch auto-test. If condition
		persists, note the code number and call an authorized technician.
	Other F__ Error appears in the	Turn power off and turn it back on again after a few seconds. If condition
	display window.	persists, note the code number and call an authorized servicer.
	The oven display stays OFF	Turn off power at the main power supply (fuse or breaker box). Turn breaker
		back on. The oven should reset itself and will be operable.
		If condition persists, call an authorized service center.
	Cooling fan continues to run	This is normal . The fan turns off automatically when the electronic
	after oven is turned off	components have cooled sufficiently.
	Oven door is locked and will not	Turn the oven off at the circuit breaker and wait a few seconds. Turn breaker
	release, even after cooling	back on. The oven should reset itself and will be operable.
	Oven is not heating	Make sure the oven temperature has been selected. Check the circuit breaker
		or fuse box to your house. Make sure there is proper electrical power to the
		oven.
	Oven is not cooking evenly	Check oven calibration. Adjust calibration if necessary (see Oven Offset,
		Page 17). Refer to cooking charts for recommended rack position.
		Always reduce recipe temperature by 25°F when baking with convention bake
		mode.
	Oven temperature is too hot or	The oven thermostat needs adjustment. See Calibrating Oven Temperature,
	too cold	Page 17.
	Oven light is not working	Replace or reinsert the light bulb if loose or defective. See Page 15. Touching
	properly	the bulb with fingers may cause the bulb to burn out.
	Oven light stays on	Oven light comes on automatically when oven begins heating. Press LIGHT to
		turn oven light off. If oven is off, check for obstruction in oven door or check to
		see if hinge is bent.
	Cannot remove lens cover on	There may be soil build-up around the lens cover. Wipe lens cover area with
	light	a clean dry towel prior to attempting to remove the lens cover.
	Oven will not self-clean properly	Allow the oven to cool before running self-clean. Always wipe out loose soil or
		heavy spills before running self-clean. If oven is badly soiled, set oven for a
		four-hour Self-Clean. See Self-Cleaning, Page 13.
	Clock and timer are not working	Make sure there is proper electrical power to the oven. See the Clock and
	properly	Timer sections on Pages 2 and 8.
	Excessive moisture	When using bake mode, preheat the oven first. Convection bake will eliminate
		any moisture in oven (this is one of the advantages of convection).
	Porcelain chips	When oven racks are removed and replaced, always tilt racks upward and do
		not force them to avoid chipping the porcelain.

English • 19