CONTROLS AND INDICATORS
REMOTE CONTROL UNIT
● Wireless remote control | Operations performed by buttons marked "❋" can |
| also be carried out by using buttons with the same |
| name on the main unit (See page 12). |
❋Record buttons
|
|
|
| (REC) |
MODEL 8317 |
|
|
| NOTE: For recording, |
REC |
|
|
| press the 2 buttons simultaneously |
| ||||
|
|
|
|
|
| TRACK NO. |
| ❋ Manual TRACK NO. |
|
| FADER |
| WRITE button |
| |
FADER button | WREITE |
| Acceptance of commands from | ||
|
| ||||
|
|
|
| ||
|
|
|
| ❋ Record muting button | the wireless remote controller |
|
|
|
| by the CR300 can be set using | |
|
|
|
|
| |
PEPEAT button | REPEAT |
|
|
| the MENU button function. |
|
|
| ❋ Manual search button | (See page 24) | |
|
|
|
|
| |
|
|
|
| ❋ Track search button |
|
| 1 | 2 | 3 | ❋ Stop button |
|
| ❋ Pause button |
| |||
Numeric buttons |
|
|
|
| |
4 | 5 | 6 | ❋ Play button |
| |
(1 to 10, >10) |
|
| |||
|
|
|
|
| |
| 7 | 8 | 9 |
|
|
Program button
(PGM)
Program check button
(CHECK)
10 
10 TIME
PGM CHECK CLEAR
❋Time button (TIME)
❋Program clear button (CLEAR)
Remote control sensor Point the remote control unit and press its buttons.
30
30
●Parallel remote control
The CR300 can be controlled through the rear panel parallel remote control input connector and also with the wireless remote controller included with the CR300.
7m(23 ft)
Remote controllable range
DIN 8 pin connector
PARALLEL
REMOTE
The CR300 can be controlled with external switches by utilizing the circuit shown below.
|
| 7 |
| 6 |
|
|
GND | WRITENO | 3 | 8 | 1 |
|
|
5 | 2 | 4 |
|
| ||
|
|
| Not Use |
|
| |
|
|
|
|
|
| |
PLAY | MANUAL TRACK |
|
| PAUSE | REC | STOP |
Caution on the remote control operation
•Remote control might not work if there is an obstacle between the remote control unit and the CR300 or if the remote control unit is operated at too great of an angle from the remote control sensor.
•Erroneous operation may occur in strong light such as direct sunlight or fluorescent lamp light shining into the remote control sensor.
•The CR300 may operate erroneously if it is used near equipment radiating infrared rays or if the infrared remote control unit of other equipment is used near the CR300. On the contrary, if this remote control unit is operated near another piece of equipment which can be controlled with infrared rays, that equipment might not work correctly.
•Replace batteries when the remote controllable range decreases noticeably.
14
CR300
