Frymaster 1824G, 2424G manual Reverse steps 1 – 4 to reinstall blower assembly

24G SERIES FLATBOTTOM GAS FRYERS CHAPTER 1: SERVICE PROCEDURES

2.Remove blower assembly by removing four screws (two screws securing the flue outlet to the firebox, and two screws securing the blower inlet housing to the firebox). Pull the assembly out of the slot and lower to the side. Do not remove the electrical connections at this time.

3.If replacing air prover switch, remove junction box cover, mark and disconnect wiring to the switch. Remove screws securing the switch to the junction box, and then remove the switch from the blower housing. Install new switch, ensuring the switch flap is correctly positioned in the blower housing. Reattach wires removed from old switch and replace box cover.

4.If replacing blower, remove junction box cover, mark and disconnect each wire, and remove conduit fitting from junction box. Reinstall conduit fitting on new blower and reconnect wiring. Replace box cover.

5.Reverse steps 1 – 4 to reinstall blower assembly.

After removing screws (arrows), remove blower assembly from firebox by pulling outward.

Blower junction box wiring. Mark wire locations before disconnecting each wire.

1-14