Frymaster 8SMS, 8BC, 8C manual Replacing the Cookpot or Rinse Tank

8.Assemble the replacement faucet to the mounting bracket and complete the procedure by reversing Steps 1-6.

6.3.8 Replacing the Cookpot or Rinse Tank

1.Disconnect the unit from the electrical power supply and from the water supply.

2.Remove the cover from the component box, mark the element leads, disconnect them from the contactors, and pull them out of the component box.

3.Remove the top cap to expose the pot hold-down bracket assembly. Remove the two Keps nuts attaching the assembly to the cookpot or rinse tank. Loosen but do not remove the screws in the top of the bracket. Remove the two screws attaching the bracket to the cabinet frame and remove the bracket assembly from the unit. On units with a rinse tank, remove the screw

securing the connecting strip.

Remove screw in each	Remove screw from
	connecting strip.
corner and remove top cap.

Remove screws.

Loosen screws in

top of bracket.

Remove Keps nuts.

4.At the rear of the unit, disconnect the incoming water lines (and any attached quick-disconnect fittings) from the nipples protruding from the upper access panel. Remove the panel and disconnect the water level sensor and temperature probe leads. If the cooker is equipped with the Autofill feature, disconnect the Autofill water line at the frypot end.

Remove Keps nuts to

Disconnect incomingdisconnect the sensor leads. water lines from nipples.

Disconnect Autofill water

line at this fitting.

	Mark the wiring harness leads and
Remove these two screws and	disconnect the probe leads at the
remove the access panel.	push on connectors.

6-8