Frymaster 8C, 8SMS, 8BC manual Replacing the Water Faucet, plate clear of the unit

6.3.7 Replacing the Water Faucet

1.Drain the cookpot and disconnect the cooker from the electrical power supply.

2.Turn off the water supply to the cooker.

3.Disconnect the incoming water lines at the nipples that protrude from the holes in the upper access panel. If necessary, remove any quick-disconnect fittings that would prevent the access panel from being removed. Remove the two screws securing the access panel in place and remove the panel (see illustration above).

4.If the cooker is equipped with a pressure regulator, disconnect the regulator by loosening the compression fitting on the outlet side (see illustration in Section 6.3.6 above).

5.Remove the screws from the faucet mounting plate and lift the entire faucet assembly from the unit.

Remove the five screws in the

mounting plate and lift the faucet and

plate clear of the unit.

6.Separate the faucet manifold from the remainder of the plumbing as shown in the illustration below.

Loosen these fittings to separate the faucet from the water supply system.

7. Disassemble the faucet from the mounting plate by removing the jamb nut and washer.

Remove jamb nut and washer to separate the faucet from the mounting plate.

6-7