Mounting the slide-in module | Fujitsu B120 specs

Installing rack-server in/removing from rack

Installation

3.5.1 Mounting the slide-in module

1

2

ÊScrew together the front panel and the bottom tray to form a slide-in module (1 + 2).

ÊPlace the server in the slide-in module with the right side facing downward and somewhat offset toward the rear.

A26361-K646-Z102-1-7619

15

Image 23

Fujitsu B120 manual Mounting the slide-in module

Contents

Primergy B120 Are there Page A26361-K646-Z102-1-7619 Operating Manual Primergy B120Page Contents Contents Hard disk subsystem FeaturesIntroduction System board High level of availability and failure protection Introduction FeaturesPower supply Service and Support Introduction Technical dataElectrical data standard power supply Notational conventions Noise level StandardsMechanical data Environmental conditions Before operating the device SafetyInstallation and operation Important notes Batteries Important notes SafetyPoper operation of the system, warranty features Other important notes CE certificateImportant notes Modules with electrostatic sensitive components Transporting the server FCC Class B Compliance Statement Further information on environmental protection Disposal and recyclingEnvironmentally friendly product design and development Take-back, recycling and disposalPage Unpacking the server InstallationInstallation steps Connecting cables Instructions on connecting and disconnecting cablesSetting up the tower server Installation 125 240 Connecting the tower server to the line voltage Connecting the monitor to the line voltage Installing rack-server in/removing from rack Mounting the slide-in module Installation Fitting spring nuts Installing the slide-in module Mounting cage nuts Connecting the rack server to the line voltage Prepare the keyboard Installation Prepare the keyboard Tower Rack Connecting devices to the server Connecting devices to the server Unlocking/locking the tower server Enabling access to the accessible drivesPreparation for use and operation Preparation for use and operation Enabling access to the hard disk drives Operation controls Operation controls IndicatorsDrive indicators Monitor screen Switching the server on and off Specified switch-on time/switch-off time Server is switched offServer is switched on Other switch-on methods Installing the operating system Configuring the serverConfiguration with ServerStart Configuration without ServerStart Fitting the hard disk cover Locking the tower server Locking the server Cleaning the serverPage Opening and closing the tower server Opening and closing the server Opening and closing the server Opening and closing the rack server Opening and closing the rack server Page Property and data protection Page Screen stays blank Troubleshooting and tipsOperation indicator remains dark Server switches itself off No screen display or display drifts Troubleshooting and tipsFlickering stripes on the monitor screen Time and/or date is not correct System does not bootNo mouse pointer displayed on the screen Floppy disk cannot be read or written Added drive defective Drives dead at system bootError messages on the screen Disk Array Controller configuration is incorrect Scsi hard disk subsystem System components and expansions RAID level 1 and 5 without standby hard disk Scsi hard disk drivesSystem components and expansions RAID level 0 Orange indicator Replacement of Scsi hard disk drive during operationFunction of the indicators Green indicator Installing/removing a Scsi hard disk drive Scsi platter for four 1-inch hard disk slide-in modules Scsi drive Accessible drivesIDE drive Open the server see Opening and closing the server Installing/Removing an accessible 5 ¼-inch drive Changing the floppy disk drive Removing/installing boards ChipDISK for RemoteView Installing/removing the chipDISK Configuring the chipDISK Replacing the system fan System board Adapter modulePage ECC Index Keyboard Index SCSI-ID Troubleshooting and tips