System components and expansions

The SCSI hard disk subsystem

8.1.3 Installing/removing a SCSI hard disk drive

If a hard disk drive is to be installed in a bay in which no hard disk drive is previously installed, then the blind insert must be removed from this bay beforehand.

1

2

ÊSwivel the slide-in module handle of the hard disk slide-in module completely upward to release the locking mechanism (1) and pull the blank insert out of the installation by (2) by the handle.

The blank insert is installed in the reverse order.

Keep the blank insert for future use. If the hard disk drive is removed again and not ! replaced with a new drive, then the blank insert must be reinstalled due to cooling, the

applicable EMC regulations (regulations on electromagnetic compatibility) and fire protection.

2

1

ÊPush the hard disk carrier into the bay (1) as far as possible and then swing down the carrier handle completely to enable the locking mechanism to engage (2).

The removal of the hard disk carrier is performed in the reverse order.

46

A26361-K646-Z102-1-7619

Page 54
Image 54
Fujitsu B120 manual Installing/removing a Scsi hard disk drive