Continued from the previous page

Are the Pick roller, the Brake roller and the Pinch rollers dirty?

NO

YES

Clean the dirty parts. (* 5)

5

NO

Are the Pick roller unit and the Brake roller unit installed properly?

YES

YES

Have you scanned many sheets? Check consumables life to ensure you have not scanned more than 300,000 pages. (* 7)

NO

Contact an authorized FUJITSU

Scanner service provider.

Install the Pick roller and the Brake roller properly. (* 6)

Replace the Pick roller unit and the Brake roller unit if necessary. (*6)

PROBLEMS COMMON SOLVING

(* 1)For the details on required conditions, refer to the section "6.2 Document Quality" on page 6-3.

(* 2)For the details on how to set up the Paper Length, refer to "7.3 Setup Mode Details", "10. Setting Short document scan mode (Paper Length setup)" on page 7-37.

(* 3)For the details on how to clean ADF, refer to "Chapter 3 DAILY CARE" on page 3-1.

(* 4)For the details on how to replace Pas ASSY, refer to "4 REPLACEMENT OF CONSUMABLES" on page 4-1.

(* 5)For the details on scanner cleaning, refer to "Chapter 3 DAILY CARE" on page 3-1.

(* 6)For the replacement and re-installation of Pick roller unit and Brake roller unit, please refer to "4 REPLACEMENT OF CONSUMABLES" on page 4-1.

(* 7)Check the consumable wear. For the method to check the number of sheets scanned for each consumable, refer to “7.3 Setup Mode Details”, “9. Abrasion counter reset” on page 7-34.

5.2 Troubleshooting 5-25