Documents Guide lever Both sides | Fujitsu M3093DE/DG guide

Set the guides so that there is a

7 little amount of clearance between the side edges and the guides. Load the document face down on the ADF paper chute and adjust the guides to the document size.

NOTE

•Squeeze the guide lever to free the guides.

•Load documents so that the thickness is less than 4mm.

• Set the guides so that they touch the document sides.

max 4mm

(0.16")

Documents	Guide lever
Guide	(Both sides)
Guide

After the read command is issued

8 from the host system, scanned documents are stacked in the stacker for removal.

2-6

Page 24

Image 24

Fujitsu M3093DE/DG manual Documents Guide lever Both sides

Contents

M3093DE/DG Image Scanner Page Page Fujitsu Australia Limited Important Note to Users Preface Conventions Page Contents Page Description Operating Instruction Page Description Units No. Function Assemblies Guide aRetaining Thumb screw Spring Consumables Bearing Indicators Power Read CheckPower Page Operating Instruction Loading Document on the ADF Lift up the ADF lever to open Set the paper select lever as Follows Close the ADFPull up the ADF paper chute until It clicks Fan the sheets before setting Document on the ADF paperChute Angle the document edges as follows Documents Guide lever Both sides Loading Document on the Flatbed Loading Document Larger than the Document Board Reading a Page from a Thick Book Page Cleaning Cleaning Supplies and Cleaning Area Supplies Cleaning area Flatbed Cleaning the ADF Lift up the ADF lever to open the ADF Remove dirt and dust as follows Pick roller Sheet guide white part Wipe the sheet guide Cleaner F2 Surface with clean and dryMoisten a cotton swab with Wipe the Plastic roller Cleaning the Flatbed Apply Cleaner F1 to a clean clothWipe the document holding pad Allow to dry Replacement of Parts Pad ASY or Pad Slide the paper selectLever to N Slide the pad ASY to the left Attach the pad ASY to the ADF Until it clicks in the reverseSequence of step Pick Roller Lift up the ADF lever to open Remove the two thumb screws Slide the pick roller to the retaining Spring side until the axisOpposite side is disengaged Lift and remove it Attach the retaining spring to a New roller Attach the Guide a in the reverse Sequence of and alignScrew hole Tighten the thumb screws Close the ADF unit Page Troubleshooting Paper JAM Remove the documents fromADF paper chute Close the ADF until the ADF lever Contact manufacturer’s authorized service center Connect the power cable correctly Press the power switchInitial Checks Are the documents loaded on the ADF Is the baud rate System 4800 bps? Default is 4800 bps Is halftone or dithering processing selected? Select a Line Art mode from Select the Photo mode White level following offClean the dirty parts Host computer Is the surface of the ADF Check Clean the pick roller Clean or replace the Pad ASYFlatten the curl or use Flatbed to read the document Do not mix different width documents Symptom8 Paper double feed occurs frequently Is the height of document less than 0.16 4mm? Install it correctly See p4-2 Flatten the curl or use the flatbed to read the documentSet the select lever to T. See p2-3 Clean the pick roller. See p3-4, p3-6 Replace the pick roller. See p4-4 YES Test Mode for Maintenance LED status on error Problem Checklist General

Documents

Guide lever

(Both sides)