Select a Line Art mode from, Host computer | Fujitsu M3093DE/DG

Symptom4 Characters and lines are not read correctly.

	NO
	NO
Is the “Line Art” mode				Select a “Line Art” mode from
selected?				the host computer.
YES


	YES
Is there printed text on				Select the “Photo” mode


				(White level following off)
the first 3mm of the				(White level following off)
document?				via software.
NO



Is the document bed,	NO			Clean the dirty parts.
Is the document bed,
document holding pad,
document holding pad,				(See p3-5, p3-7, p3-9)
glass and sheet guide				(See p3-5, p3-7, p3-9)
clean?

YES

Contact manufacturer’s authorized service center.

TROUBLESHOOTING

5-7

Image 52

Fujitsu M3093DE/DG manual Select a Line Art mode from, Host computer, Select the Photo mode White level following off

Contents

M3093DE/DG Image Scanner Page Page Fujitsu Australia Limited Important Note to Users Preface Conventions Page Contents Page Description Operating Instruction Page Description Units No. Function Guide a AssembliesRetaining Thumb screw Spring Consumables Bearing Power Read Check IndicatorsPower Page Operating Instruction Loading Document on the ADF Lift up the ADF lever to open Set the paper select lever as Follows Close the ADFPull up the ADF paper chute until It clicks Document on the ADF paper Fan the sheets before settingChute Angle the document edges as follows Documents Guide lever Both sides Loading Document on the Flatbed Loading Document Larger than the Document Board Reading a Page from a Thick Book Page Cleaning Cleaning Supplies and Cleaning Area Supplies Cleaning area Flatbed Cleaning the ADF Lift up the ADF lever to open the ADF Remove dirt and dust as follows Pick roller Sheet guide white part Wipe the sheet guide Cleaner F2 Surface with clean and dryMoisten a cotton swab with Wipe the Plastic roller Cleaning the Flatbed Apply Cleaner F1 to a clean clothWipe the document holding pad Allow to dry Replacement of Parts Pad ASY or Pad Slide the paper selectLever to N Slide the pad ASY to the left Until it clicks in the reverse Attach the pad ASY to the ADFSequence of step Pick Roller Lift up the ADF lever to open Remove the two thumb screws Slide the pick roller to the retaining Spring side until the axisOpposite side is disengaged Lift and remove it Attach the retaining spring to a New roller Sequence of and align Attach the Guide a in the reverseScrew hole Tighten the thumb screws Close the ADF unit Page Troubleshooting Paper JAM Remove the documents fromADF paper chute Close the ADF until the ADF lever Connect the power cable correctly Press the power switch Contact manufacturer’s authorized service centerInitial Checks Are the documents loaded on the ADF Is the baud rate System 4800 bps? Default is 4800 bps Is halftone or dithering processing selected? Select a Line Art mode from Select the Photo mode White level following offClean the dirty parts Host computer Is the surface of the ADF Check Clean the pick roller Clean or replace the Pad ASYFlatten the curl or use Flatbed to read the document Do not mix different width documents Symptom8 Paper double feed occurs frequently Is the height of document less than 0.16 4mm? Flatten the curl or use the flatbed to read the document Install it correctly See p4-2Set the select lever to T. See p2-3 Clean the pick roller. See p3-4, p3-6 Replace the pick roller. See p4-4 YES Test Mode for Maintenance LED status on error Problem Checklist General