Paper JAM, Remove the documents from, Locks | Fujitsu M3093DE/DG

Paper JAM

Document

ADF

ADF lever

1	Remove the documents from
	the ADF paper chute.

2

3

Lift the ADF lever to open the ADF.

Remove the jammed document.

NOTE

Inspect the paper and paper path. Make sure no staples, paper clips or other materials caused the jam. All types of staples and paper clips should be removed from all documents bofore scanning.

4	Close the ADF until the ADF lever
	locks.

5-2

Image 47

Fujitsu M3093DE/DG manual Paper JAM, Remove the documents from, ADF paper chute, Close the ADF until the ADF lever, Locks

Contents

M3093DE/DG Image Scanner Page Page Fujitsu Australia Limited Important Note to Users Preface Conventions Page Contents Page Description Operating Instruction Page Description Units No. Function Retaining Thumb screw Spring Consumables Bearing AssembliesGuide a Power IndicatorsPower Read Check Page Operating Instruction Lift up the ADF lever to open Loading Document on the ADF It clicks Set the paper select lever as FollowsClose the ADF Pull up the ADF paper chute until Chute Fan the sheets before settingDocument on the ADF paper Angle the document edges as follows Documents Guide lever Both sides Loading Document on the Flatbed Loading Document Larger than the Document Board Reading a Page from a Thick Book Page Cleaning Supplies Cleaning Supplies and Cleaning Area Flatbed Cleaning area Cleaning the ADF Remove dirt and dust as follows Lift up the ADF lever to open the ADF Pick roller Sheet guide white part Wipe the sheet guide Wipe the Plastic roller Cleaner F2Surface with clean and dry Moisten a cotton swab with Allow to dry Cleaning the FlatbedApply Cleaner F1 to a clean cloth Wipe the document holding pad Replacement of Parts Slide the pad ASY to the left Pad ASY or PadSlide the paper select Lever to N Sequence of step Attach the pad ASY to the ADFUntil it clicks in the reverse Lift up the ADF lever to open Remove the two thumb screws Pick Roller Lift and remove it Slide the pick roller to the retainingSpring side until the axis Opposite side is disengaged New roller Attach the retaining spring to a Screw hole Tighten the thumb screws Close the ADF unit Attach the Guide a in the reverseSequence of and align Page Troubleshooting Close the ADF until the ADF lever Paper JAMRemove the documents from ADF paper chute Initial Checks Contact manufacturer’s authorized service centerConnect the power cable correctly Press the power switch Are the documents loaded on the ADF Is the baud rate System 4800 bps? Default is 4800 bps Is halftone or dithering processing selected? Host computer Select a Line Art mode fromSelect the Photo mode White level following off Clean the dirty parts Is the surface of the ADF Check Flatbed to read the document Clean the pick rollerClean or replace the Pad ASY Flatten the curl or use Do not mix different width documents Symptom8 Paper double feed occurs frequently Is the height of document less than 0.16 4mm? Set the select lever to T. See p2-3 Install it correctly See p4-2Flatten the curl or use the flatbed to read the document Replace the pick roller. See p4-4 Clean the pick roller. See p3-4, p3-6 YES Test Mode for Maintenance LED status on error General Problem Checklist