6Open the right and left guides of the ADF paper chute about 5 mm wider than the document width.
7Place the documents face down onto the ADF paper chute with the top edges facing the automatic feeder hole.
8Adjust the guides to the document sides. Skewing may occur if there is a gap between the guides and documents.
9Slide the documents down until they touch the far end of the automatic feeder opening. If the documents hit the far end hard, two or more pages may be fed at once. Make sure that the upper end of documents are not turned.
10For the M3097E+, select the reading mode from the operator panel and start the read operation. For the M3097G+, the scanner starts the read operation by a command from the host system. If an incorrect document size or mode (portrait or landscape) is selected, the document may not be read entirely.
11After reading, remove the documents from the stacker.
Guide
Automatic document feeder
Documents
ADF paper chute
Guide lever
Guide
Figure 4.4 Loading the document
Portrait | Landscape |
Short side | Long side |
Automatic document feeder
ADF paper chute
Documents
4 – 8
