Upgrading From XCP104x to XCP 1050 or Later

The following steps describe the case of upgrading to XCP1060.

Note – By upgrading to XCP 1050 or later, XSCFU_B#1 will start working. When your system is using RCI network, XSCFU_B#1 needs proper configuration of cabling or termination to setup RCI network, properly.

For further information, please contact to your service provider.

Note – Do not access the XSCF units via the "Takeover IP address".

Note – LAN connections are disconnected when the XSCF resets. It is recommended to use the XSCF serial connection to simplify the XCP upgrade procedure.

1.Log in to the XSCF#0 on an account with platform administrative privileges.

2.Verify that there are no faulted or deconfigured components by using the showstatus(8) command.

XSCF> showstatus

The showstatus(8) prompt will return if there are no failures found in the System Initialization. If anything is listed, contact your authorized maintenance representative before proceeding.

Note – Take information with using BUI or snapshot(8) command. This will be help in case any problem occurred in this procedure.

3.Power off all domains.

XSCF> poweroff -a

4.Confirm that all domains are stopped:

XSCF> showlogs power

5.Move the key position on the operator panel from Locked to Service.

26 SPARC Enterprise M8000/M9000 Servers Product Notes for XCP Version 1060 • November 2007