Fujitsu MHY2040BS, MHY2160BS, MHY2200BS, MHY2120BS, MHY2080BS Read FP DMA Queued command protocol

Interface

8)If an uncorrectable error occurs during command queuing, the device sends to the host the Set Device Bits FIS with the settings of ERR bit = 1, ERRReg = ATAErrCode, I bit = 1, and SActive = 0 to report an error.

9)After reporting the error, the device accepts only the READ LOG EXT command with page 10h specified and the reset requests (SoftReset and COMRESET). The device reports abort for other commands.

10)If the device receives the READ LOG EXT command with page 10h specified, queued commands are aborted. Then, after the device sends to the host the SetDB FIS (ERR = 0, ERRReg = 0, I = 0, and SActive =0xFFFFFFFF), it sends to the host the log data for the READ LOG EXT command with page 10h specified and reports the status of this command. Next, the command queuing function is enabled, and commands can be accepted again.

Host

RegHD

RegDH

Device

DMA Setup

DATA

SetDB

Figure 5.18 READ FP DMA QUEUED command protocol

5-184 C141-E269