Fujitsu MHY2200BS, MHY2160BS, MHY2120BS, MHY2040BS, MHY2080BS, MHY2060BS, MHY2100BS Connector pinouts

5.1 Physical Interface

5.1.4 Connector pinouts

The pin definitions are shown in Table 5.1.

Table 5.1 Connector pinouts

Signal segment key

		S1	Gnd	2nd mate
		S2	A+	Differential signal pair A from Phy
Signal	segment	S3	A-
		S4	Gnd	2nd mate
		S5	B-	Differential signal pair B from Phy
		S6	B+
		S7	Gnd	2nd mate
		"Key and spacing separate signal and power segments"
		P1	V33	N.C.(Open)
		P2	V33	N.C.(Open)
		P3	V33	N.C.(Open)
		P4	Gnd	1st mate
		P5	Gnd	2nd mate
		P6	Gnd	2nd mate
		P7	V5	5 V power, pre-charge, 2nd mate
		P8	V5	5 V power
		P9	V5	5 V power
Power	segment
		P10	Gnd	2nd mate
		P11	Staggered	• Staggered Spin-up mode detect for input
			Spin-up Mode/	• Activity LED drive for output
			Activity LED
				For the specification of P11, see Section
				5.1.5. (in next page)
				When the host system does not use these
				function, the corresponding pin to be mated
				with P11 in the power cable receptacle
				connector shall be grounded.
		P12	Gnd	1st mate
		P13	V12	N.C.(Open)
		P14	V12	N.C.(Open)
		P15	V12	N.C.(Open)

Power segment key

Notes:

Note) Since applying a single external supply voltage of 5 V enables this drive to operate it is unnecessary to supply +3.3 V and +12 V power supplies.

C141-E269 5-7