6.4 Log Messages
Server Status Change (CODE 012)
[Explanation] | There has been a change in the target device’s status. |
[Response] | If the component that caused the problem is included in the message, login to the |
| target device and check the status of that component. |
| When "No hardware error detected." is displayed, there is no need to do anything. |
| Detection of the offline status is indicated when "No hardware report detected. |
| (Offline)" is displayed. In this case, check for problems with the target device, fail- |
| ures in the communications route, and errors in the setup file. |
Work files create to "temp directory" (CODE 014)
[Explanation] | ETERNUSmgr has created a work file in the directory indicated in this message. |
[Response] | None |
■Warning Messages for Parameter Settings (CODE 1XX)
Bad Parameter "parameter" (CODE 102)
[Explanation] | This parameter setting is invalid. |
[Response] | Correct the parameter setting. |
Undefined Parameter "parameter" (CODE 103)
[Explanation] | This parameter setting is not recognized. |
[Response] | Correct the parameter setting. |
Parameter too long "parameter" (CODE 104)
[Explanation] | Too many characters are used in this parameter setting. |
[Response] | Correct the parameter setting. |
Not NULL Parameter "parameter" (CODE 105)
[Explanation] | NULL is not allowed for this parameter setting. |
[Response] | Set the parameter. |
Directory Name too long "directory name" (CODE 106)
[Explanation] | The directory name is too long. |
[Response] | Set a shorter directory name. |
■Warning Messages (CODE 3XX)
Can't Connect Server "server:port" (CODE 301)
[Explanation] | Failed to connect to the machine. |
[Response] | Check the network environment (IP address, etc.). |
Can't Send Mail "name@server" (CODE 304)
[Explanation] | Failed to send an |
[Response] | Check the mail server is operating. |
50
ETERNUSmgr User Guide -Introduction- P2X0-0202-01EN
All Rights Reserved, Copyright © FUJITSU LIMITED 2007
