Installing the CD-ROM/DVD drive | Fujitsu RX200 specification

Installing a CD-ROM/DVD drive

Accessible Drives

2

1

Figure 18: Installing the CD-ROM/DVD drive

ÊPlug the data cable (1) and the power cable (2) into the CD-ROM/DVD drive.

ÊClose the server, plug in the power plugs, and switch on the server as described in the chapter “Completion” on page 45f.

34	OptionsGuide

Image 42

Fujitsu RX200 manual Installing the CD-ROM/DVD drive

Contents

Primergy RX200 S2 Serversystem Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOPage Page Abbreviations Related publications Index Page Contents Page Concept and target groups PrefaceOverview of the documentation Additional documentation about the server Overview of the documentation Preface Further sources of information Second processor Additional accessible drivesExtensions and conversions Extension of the main memory RemoteView Service Board S2 LP RemoteView Notational conventions Page Procedure Page Safety Instructions Before setting up Installation and operation Page Batteries Modules with electrostatic-sensitive devices ESD labelPage Preparation Opening the server Opening the server Removing the cover Installation rules Main Memory Upgrading / exchanging main memory Upgrading / exchanging main memory Installing a second processor Processors Installing a second processor Removing the ventilation duct Installing the processor ProcessorsRemoving the heat sink dummy Vcaution Installing the heat sink Installing the ventilation duct Exchanging the processor Exchanging the processor Exchanging the processor Exchanging the processor Exchanging the heat sink Page Accessible Drives Installing the LocalView Module Installing the LocalView Module Accessible Drives Connecting the LocalView module Installing a CD-ROM/DVD drive Installing a CD-ROM/DVD driveRemoving the dummy cover Installing a CD-ROM/DVD drive Installing the CD-ROM/DVD drive Installing a floppy disk drive Installing a floppy disk drive Removing/installing a floppy disk drive Connecting the data cable Page Controllers in Non-Hot-Plug PCI Slots Installing a PCI board Installing controllersInstalling controllers Removing the riser card holder Reinstalling the riser card holder Mounting the boardPage Installing the RemoteView Service Board S2 LP RemoteView Components Remove the slot cover Completion Closing the server Installing the server Closing the server Abbreviations Abbreviations GAM LVD Rtds Page Related publications Integrated Mirroring User’s Guide Index Upgrade Comments Suggestions Corrections Page Comments Suggestions Corrections