Completion, Closing the server | Fujitsu RX200 specs

10 Completion

VCAUTION!

Please observe the safety information in the chapter “Safety Instructions” on page 9ff.

10.1Closing the server

Figure 25: Installing the cover

ÊPosition the cover in such a way that the rear edge protrudes 3-4 cm from the housing.

ÊPush the cover to the front as far as it will go.

ÊAttach the cover with the knurled screw (see circle in figure) at the back of the housing.

ÊInstall the server in the rack.

IHow to install the server in the rack is described in the operating manual.

OptionsGuide

45

Image 53

Fujitsu RX200 manual Completion, Closing the server

Contents

Primergy RX200 S2 Serversystem Certified documentation according to DIN EN ISO Comments… Suggestions… Corrections…Page Page Abbreviations Related publications Index Page Contents Page Overview of the documentation PrefaceConcept and target groups Additional documentation about the server Further sources of information Overview of the documentation Preface Extensions and conversions Additional accessible drivesSecond processor Extension of the main memory RemoteView RemoteView Service Board S2 LP Notational conventions Page Procedure Page Before setting up Safety Instructions Installation and operation Page Batteries ESD label Modules with electrostatic-sensitive devicesPage Opening the server Preparation Removing the cover Opening the server Main Memory Installation rules Upgrading / exchanging main memory Upgrading / exchanging main memory Processors Installing a second processor Removing the ventilation duct Installing a second processor Removing the heat sink dummy Installing the processorProcessors Vcaution Installing the ventilation duct Installing the heat sink Exchanging the processor Exchanging the processor Exchanging the processor Exchanging the processor Exchanging the heat sink Page Accessible Drives Installing the LocalView Module Installing the LocalView Module Connecting the LocalView module Accessible Drives Removing the dummy cover Installing a CD-ROM/DVD driveInstalling a CD-ROM/DVD drive Installing a CD-ROM/DVD drive Installing the CD-ROM/DVD drive Installing a floppy disk drive Removing/installing a floppy disk drive Installing a floppy disk drive Connecting the data cable Page Controllers in Non-Hot-Plug PCI Slots Installing controllers Installing controllersInstalling a PCI board Removing the riser card holder Mounting the board Reinstalling the riser card holderPage RemoteView Components Installing the RemoteView Service Board S2 LP Remove the slot cover Closing the server Completion Closing the server Installing the server Abbreviations Abbreviations GAM LVD Rtds Page Related publications Integrated Mirroring User’s Guide Index Upgrade Comments Suggestions Corrections Page Comments Suggestions Corrections