Installing controllers, Installing a PCI board | Fujitsu RX200

Installing controllers

Controllers in Non-Hot-Plug PCI Slots

8.1Installing controllers

ÊOpen the server as described in the chapter “Preparation” on page 15f.

Removing the riser card holder

Figure 22: Removing the riser card holder

ÊUndo the two knurled screws (see figure).

ÊPull out the riser card holder upwards.

Installing a PCI board

ÊPlease read the documentation supplied with the PCI board.

ÊPlug any necessary cables into the PCI board.

ÊRemove the slot cover from the PCI board.

IKeep the slot cover for future use. If you remove the board without installing a new one, you must reinstall the slot cover to comply with EMC regulations (regulations on electromagnetic compatibility) and to satisfy cooling requirements and fire protection measures.

40	OptionsGuide

Image 48

Fujitsu RX200 manual Installing controllers, Removing the riser card holder, Installing a PCI board

Contents

Primergy RX200 S2 Serversystem Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOPage Page Abbreviations Related publications Index Page Contents Page Preface Overview of the documentationConcept and target groups Additional documentation about the server Overview of the documentation Preface Further sources of information Additional accessible drives Extensions and conversionsSecond processor Extension of the main memory RemoteView Service Board S2 LP RemoteView Notational conventions Page Procedure Page Safety Instructions Before setting up Installation and operation Page Batteries Modules with electrostatic-sensitive devices ESD labelPage Preparation Opening the server Opening the server Removing the cover Installation rules Main Memory Upgrading / exchanging main memory Upgrading / exchanging main memory Installing a second processor Processors Installing a second processor Removing the ventilation duct Installing the processor ProcessorsRemoving the heat sink dummy Vcaution Installing the heat sink Installing the ventilation duct Exchanging the processor Exchanging the processor Exchanging the processor Exchanging the processor Exchanging the heat sink Page Accessible Drives Installing the LocalView Module Installing the LocalView Module Accessible Drives Connecting the LocalView module Installing a CD-ROM/DVD drive Installing a CD-ROM/DVD driveRemoving the dummy cover Installing a CD-ROM/DVD drive Installing the CD-ROM/DVD drive Installing a floppy disk drive Installing a floppy disk drive Removing/installing a floppy disk drive Connecting the data cable Page Controllers in Non-Hot-Plug PCI Slots Installing controllers Installing controllersInstalling a PCI board Removing the riser card holder Reinstalling the riser card holder Mounting the boardPage Installing the RemoteView Service Board S2 LP RemoteView Components Remove the slot cover Completion Closing the server Installing the server Closing the server Abbreviations Abbreviations GAM LVD Rtds Page Related publications Integrated Mirroring User’s Guide Index Upgrade Comments Suggestions Corrections Page Comments Suggestions Corrections