Furuno 1943C-BB, 1953C-BB, 1933C-BB Navigating to ports, port services NavCharts/C-MAP, QP window

3. PLOTTER OPERATION

Selecting an external waypoint

You can select a waypoint (or route) entered at an external plotter connected with NMEA cable. This function requires the RMB data sentence.

1.Press the [MENU] key, B:PLOTTER SETUP soft key to show the PLOTTER SETUP menu.

2.Use the trackball to select QP.

3.Press the C:ENTER soft key or [ENTER] knob to show the QP window.

QP°

§EXT WPT (RMB) INTERNAL

QP window

4.Select EXT WPT (RMB).

5.On a connected external plotter, set a waypoint (or route) as the destination. Selected waypoint (route) appears on the NavNet plotter screen. (on radar screen, a lollipop appears to show the waypoint.)

3.10.3Navigating to ports, port services (NavCharts™/C-MAP)

NavCharts™/C-MAPhave a port service list which shows services available at ports or harbors. (See page 3-13.) You can use the list to set your destination as follows:

1.Select “35 PTS/PORT SVC” following the procedure in “Selecting quick point entry method” on page 3-44.

2.Place the cursor on the location desired, then press the D:GOTO soft key.

Soft key titles change as in the figure below.

+	40° 45.971'N	FROM	0.26 nm	GOTO
	13° 57.462'E	OS	180.2° M

16.0nm	A	QUICK
		ROUTE
	B	NEAR
		SRVC
PUNTA CORNACCHIA

ACCO AMENO

ISCHIA

PORTO

C PORT*

CASAMICCIOLA

I. ISCHIA

E CANCEL

GOTO

*NavChartsTM only

Plotter display

3.Press the C:PORT (NavCharts™ only) or B:NEAR SRVC soft key depending on objective. PORT shows a list of ports in your area. NEAR SRVC displays the port service list.

3-46 offered by Busse-Yachtshop.de