1. OPERATIONAL OVERVIEW

1.3Turning the Unit On/Off

Press the [POWER/TX] key on the control unit to turn on the power. The POWER lamp on the processor unit lights. A beep sounds and the equipment proceeds in the sequence shown below, displaying product information, startup test results and the chart usage disclaimer. The startup test checks the ROM, RAM, internal battery and backup data for proper operation, displaying the results for each as OK or NG (No Good). If NG appears try to press any key to go to the chart disclaimer screen, then perform the diagnostic test as shown in the paragraph “7.5 Diagnostics.”

Chart List

Host Name

 

** = Program version no. for￿

* = "GD-1900C-BB Plotter" for GD-1900C-BB

FURUNO/NAVIONICS￿

model. 1950010 XXX for C-MAP model.￿

#= Name determined at installation.

XXX = program version no.

 

RADAR PLOTTER*

STATION NAME: RADAR#

FURUNO ELECTRIC CO., LTD. CHARTS AVAILABLE

LICENSE NO.

Î

STARTUP TEST

ROM

OK

 

 

RAM

OK

 

 

BACKUP DATA

OK

 

 

INTERNAL BATTERY

OK

Î

NO NATIONAL HYDROGRAPHIC￿ OFFICE HAS VERIFIED THE￿ INFORMATION IN THIS￿ COASTLINE DATA CARD AND NONE￿ ACCEPT LIABILITY FOR THE ￿ ACCURACY OF REPRODUCTION OR￿ ANY MODIFICATIONS MADE ￿ THEREAFTER. THIS PRODUCT WITH￿ THIS COASTLINE DATA CARD￿ DOES NOT REPLACE THE ￿ REQUIREMENT TO USE THE￿ APPROPRIATE PRODUCTS FOR￿ NAVIGATION ACCORDING TO￿ NATIONAL AND INTERNATIONAL￿ REGULATIONS.

￿

PROGRAM No. 1950011 XXX**

Product information

Startup test

 

Chart disclaimer

 

 

 

 

 

 

Startup sequence

For start up with the radar display, the magnetron takes from one minute to two minutes and thirty seconds (depending or radar model) to warm up before the radar can be operated. The time remaining for warming up the magnetron is counted down at the center of the display.

You may press any key at the chart disclaimer screen to show the last-used display, or wait several seconds to let the equipment do it for you.

To turn the unit off, press and hold down the [POWER/TX] key until the screen goes dark (approx. 3 sec.). Note that if the network sounder is connected, it will be turned off approx. three minutes after turning off the power.

Note: The first time you turn on the power (or any time the power is applied after a memory reset), you are asked if you want to start the simulation mode, which provides simulated operation of the equipment. Push the [ENTER] knob to start the simulation mode, or press the [CLEAR] key to start normal operation. For further details about the simulation mode, see the paragraph “1.10 Simulation Display.”

offered by Busse-Yachtshop.de

1-5

Page 19
Image 19
Furuno 1953C-BB, FURUNO MARINE RADAR, 1943C-BB, 1933C-BB, 1823C-BB, 1833C-BB manual Turning the Unit On/Off, Startup sequence