1. OPERATIONAL OVERVIEW

1.5.4Selecting image source

When more than one network radar or network sounder is connected to the equipment, you may select an image source for each as shown below. This is not necessary when only one network radar or network sounder is connected.

1.Press the [DISP] key.

2.Press any soft key to show the following display.

▲RADAR SOURCE

RADAR - - -

SOUNDER SOURCE

SOUNDER-

AUX SOURCE

WXFAX - - -

IP ADDRESS

172.031.003.007

HOST NAME

RADAR - - -

SELECT SOURCE

A EDIT

IF THERE IS MORE THAN ONE NETWORK RADAR OR ECHO SOUNDER, YOU MAY SELECT THE IMAGE SOURCES FOR DISPLAY.

E RETURN

Select source menu

3.Use the trackball to select RADAR SOURCE, SOUNDER SOURCE or AUX SOURCE as appropriate, then press the A: EDIT soft key.

RADAR SOURCE

SOUNDER SOURCE

AUX SOURCE

RADAR - - -

SOUNDER-

WXFAX- - - - -

Radar source

Sounder source

Aux source

Radar source and sounder source windows

4.Use the trackball and alphanumeric keys to enter source name: Adjust the trackball to select location and enter character with the alphanumeric keys.

5.Push the [ENTER] knob to set.

6.Press the [DISP] key to finish.

Note: Source names are determined at installation. For example, the source names for radars in a two-radar system might be “RADAR” and “RADAR1”.

1-10

offered by Busse-Yachtshop.de

Page 23 Page 25
Page 24
Image 24
Furuno FURUNO MARINE RADAR, 1953C-BB Selecting image source, Select source menu, Radar source and sounder source windows
Page 23 Page 25
Top Page Image Contents