
APPENDIX > TRANSFERRING MAPSOURCE DATA
To setup for data transfer:
1.Remove weather cap from the Power/Data Port on the back of the unit by lifting up on the rubber weather cap.
2.Connect the serial port connector on the cable to an available serial port on your computer.
3.Connect the remaining cable connector to the back of the Rino 120 by orienting the slot on the connector with the indexing bar on the back of the unit and push the connector until it is fully seated in the unit.
4.Turn on the Rino 120 and follow instructions for map data transfer provided in the MapSource User’s Manual. See also the “Interface Setup Page” section for unit interface settings.
Rino® 120 Owner’s Manual | 95 |