Magnum 3000 Stackable HubsInstallation and User Guide (07/06)

3. COMMUNITY

C[OMMUNITY] [# [NAME [S] [MANAGER....]]]

Used to set the community string for GET and SET operations.

#--number of community. (Up to 10 different communities may be set)

S --allow SET operations. (If you do not "S" this command, this community will allow only GET operations)

MANAGER --the network manager IP addresses list, up to 10. (If the manager IP addresses list is not present in a command line, any network manager can communicate with this agent using this community string)

Example of two managers: >C 3 MAGNUM S 45.9.0.122 45.9.1.3{Cr}

To display community, type: C{Cr}

To delete community, type: C [#] {Cr}

3. DISPLAY

To display the whole configuration file, type: D{Cr}

Example: >D{Cr} ( All configuration information will appear )

4. EXIT

To exit from the configuration menu, type E{Cr}

Example: >E{Cr}

5. GATEWAY

G[ATEWAY] [# [IP [SUBNETIP [MASKIP]]]]{Cr}

Used to set the gateway IP address and mask. Up to 10 gateways may be set.

Example: >G 3 45.9.0.112 255.255.255.0 255.0.0.0{Cr}

6. MANAGER

M[ANAGER] [# [IP/NAME [PORT] COMMUNITY]]]

Used to set the number of network manager IP addresses, and the community to which TRAPS should be sent. Up to 10 managers may be set. If "PORT" is absent, then TRAPS are sent to port 162, as specified in RFC 1157. If "COMMUNITY" is absent, the community string "public" is used by default.

Example: M 2 45.9.1.125 Magnum{Cr}

7.SUBNETMASK S[UBNETMASK] [IP]{Cr}

To set IP mask, type: S [ mask value] {Cr}

Example: >S 255.255.255.0 {Cr}

NOTE: After entering information using the commands above, to make the new configuration

operative, exit from the configuration menu by typing: E {Cr}. If the agent's IP address has been changed, reset the agent (via a unit power down) to install the change.

www . GarrettCom . com

42

Page 49
Image 49
GarrettCom Magnum 3000 manual Community Community # Name S Manager, Manager Manager # IP/NAME Port Community