GarrettCom Magnum 3000 Remove Chassis Cover of the hub, 3b Magnum 3024, Top View with Cover Off

Magnum 3000 Stackable Hubs Installation and User Guide (07/06)

Step 1. Remove Chassis Cover of the hub

The chassis cover is made in one piece, forming the top and the front of the unit. There are 7 screws located on top and 3 on the front of the unit as shown below. Remove these screws. Once these are removed, the chassis cover/front is easily lifted forward and off of the chassis base. (See Figure 5.3a).

10 Phillips Head Screws

One piece cover,

top and front

Chassis Cover

Magnum 3000

Stackable Hub

1 2 3 4 5 6 7 8 9 1310 14 11 15 1216 17 18 19 20 21 22 23 24

GARRETT

Ventilation

Slots

Magnum 3024

Figure 5.3a: Removing Magnum 3024 / 3012 Chassis Cover

Step 2. Insert the Agent Board (Magnum 3024 and 3012 Hubs)

Looking down into the Magnum 3024 or 3012 hub as shown in the illustration Figure 4.3c below, the Embedded Agent Board mounts on top of the other printed circuit boards in the left-rear area of the unit. Three screws with stand-offs hold it firmly in place in the correct position.

Back of Unit

	Power Supply	AC Power
Optional Bonus Port		Input

Left Side

Front of Unit

Right Side

Figure 5.3b: Magnum 3024, Top View with Cover Off

The Magnum SNMP embedded agent daughter board, Figure 4.3d, connects into the DB-9 connector "P1" on the back of the Magnum 3000 unit with a cable, and

www . GarrettCom . com

37