GarrettCom Magnum 3000 manual Specifications Repeater Port Modules RPMs Bonus Ports

Magnum 3000 Stackable Hubs Installation and User Guide (07/06)

1.1Specifications - Repeater Port Modules (RPMs); Bonus Ports

RPM Type :	BNC	AUI	DTE	Fiber-mm Fiber-sgl.m		TP*
Front Access	yes	yes	yes	yes	yes	yes
Connector Type	BNC-f	DB-15 f	DB-15 m	Fiber-ST Fiber-ST		RJ-45
Partition (PART)LED	yes	yes	yes	yes	yes	yes
Receive (RX) LED	yes	yes	yes	yes	yes	yes
LINK LED	n.a.	n.a.	n.a.	yes	yes	yes
Switch on Face Plate	yes**	n.a.	n.a.	n.a.	n.a.	yes***

“Fiber-mm” is multi-mode cable, normally used for 10BASE-FL installations, up to 2.0Km.

“Fiber-sgl.m” is single-mode cable, used for distant installations, up to 10.0Km.

*The RJ-45 connector is shielded; it accepts RJ-45 eight-pin plugs for unshielded and shielded twisted pair wiring.

**Internal termination switch for BNC, no "T" connector is required.

***MDI-X (Media Dependent Interface - Crossover) switch for RJ-45 uplink,

no crossover cable is required.

1.2Specifications - Bridge Port Modules (BPMs); Bonus Ports

BPM Type :	BNC	AUI	Fiber	TP*
Connector Type	BNC(f)	DB-15(f)	ST	RJ-45
Switch on FP	yes**	n.a.	n.a.	yes***
FWD-I LED	yes	yes	yes	yes
FWD-X LED	yes	yes	yes	yes
LINK LED	n.a.	n.a.	yes	yes

*The RJ-45 connector is shielded; it accepts RJ-45 eight-pin plugs for unshielded and shielded twisted pair wiring.

**Internal termination switch for BNC, no "T" connector is required.

***MDI-X (Media Dependent Interface - Crossover) switch for RJ-45 uplink,

no crossover cable is required.

www . GarrettCom . com

3