
www.gateway.com | Installing and removing drives |
11Align the optical drive with the two clips on the left side of the optical drive tray, then press the optical drive into place in the tray.
12Insert the optical drive tray into the bay in the media cage until it clicks into place.
13Insert the media cage into the assembly bay in the chassis.
14Secure the assembly by tightening the thumbscrew you previously loosened.
15Attach the
16Reinstall the large fan cage by following the instructions in “Replacing system fans” on page 46.
17Follow the instructions in “Closing the server case” on page 32.
18Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
19Reconnect all power cords and peripheral device cables, then turn on the server.
Removing and installing a tape drive
To remove and install a tape drive:
Caution
The tape drive is not
1Follow the instructions in “Preventing static electricity discharge” on page 30. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.
2Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
3Follow the instructions in “Opening the server case” on page 31.
4Remove the large fan cage by following the instructions in “Replacing system fans” on page 46.
5Disconnect the data and power cables from the tape drive.
6Loosen the thumbscrew (1) holding the media cage in the chassis, then push the assembly (2) out the front of the chassis.
35