www.gateway.com

Installing and removing an optional mezzanine board

4Align the holes on one side of the board with the plastic standoffs (1) and align the other side with the mezzanine board slot (2).

3

2

5Push down on the board (3) to seat it in the mezzanine board slot and onto the plastic standoffs until the retaining tabs snap into place.

6Replace the PCI riser card assembly by following the instructions in “Installing and removing PCI expansion cards” on page 44.

7Follow the instructions in “Closing the server case” on page 32.

To remove an optional mezzanine board:

1Follow the instructions in “Preventing static electricity discharge” on page 30. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.

2Follow the instructions in “Opening the server case” on page 31.

3Remove the PCI riser assembly by following the instructions in “Installing and removing PCI expansion cards” on page 44.

4Push aside the plastic retaining tabs (1) and pull the mezzanine board (2) out of the mezzanine board slot.

5Replace the PCI riser card assembly by following the instructions in “Installing and removing PCI expansion cards” on page 44.

6 Follow the instructions in “Closing the server case” on page 32.

57