CHAPTER 4: Installing Components

www.gateway.com

6Make sure that the tray’s release lever is open, then slide the new drive fully into the empty hot-swap drive bay.

7Push the lever back into place, then turn the lock clockwise to secure the hard drive in the bay.

8Reinstall the bezel, if required, by snapping it into place on the front of the chassis.

Removing and installing a diskette drive

Caution

The diskette drive is not hot-swappable. Before installing or removing the drive, make sure that power is turned off and the power cord is unplugged.

To remove and install a diskette drive:

1Follow the instructions in “Preventing static electricity discharge” on page 30. Make sure that you turn off the server, then unplug the power cord(s) and all other cables connected to the server.

2Unlock the bezel (if necessary) and remove it by pulling it from the chassis.

3Follow the instructions in “Opening the server case” on page 31.

4Disconnect the USB cable from the diskette drive.

5Lift the blue locking tab on the back of the diskette drive tray, then push the drive tray out the front of the media cage.

Blue locking tab

38