CHAPTER 4: Installing Components | www.gateway.com |
8Loosen the two thumbscrews (1) that secure the system board to the server.
22
22
2
1 | 2 |
2
9Slide the system board toward the back of the server until it is free of the eight retaining standoffs (2), then lift the board from the chassis.
10Place the old system board in a
11Insert the new system board into the chassis, aligned with the eight retaining standoffs, then slide the board toward the front of the case so the board is held by the standoffs.
12Tighten the two system board thumbscrews to secure the board into the chassis.
13Connect the cables you removed in Step 7.
14Install the memory by following the instructions in “Installing memory” on page 40.
62