www.gateway.com

Replacing the hot-swap backplane

10Holding the new backplane by the edges only, align it with the locking tabs on the backplane bracket, then place it on the locking tabs (1).

11Slide the backplane to the right, locking it into place on the backplane bracket.

12Insert the backplane bracket and backplane into the chassis (3) between the two rows of button-shaped fixtures on the bottom of the chassis.

13Reconnect all cables to the backplane.

14Replace the system fans and fan duct by following the instructions in “Replacing system fans” on page 46.

15Follow the instructions in “Closing the server case” on page 32.

16Reinstall the hot-swap drives back into the server. Make sure that you install the drives into the same bays you removed them from in Step 4. For instructions see “Removing and installing a hard drive” on page 37.

17Replace the bezel by snapping it into place on the front of the server.

55