www.gateway.com

Troubleshooting

Bootblock recovery code checkpoints

The bootblock recovery code gets control when the BIOS determines that a BIOS recovery needs to occur because the user has forced the update or the BIOS checksum is corrupt. The following table provides the diagnostic LED codes for these checkpoints and describes the type of checkpoints that may occur during the Bootblock recovery portion of the BIOS:

Check

Description

point

 

 

 

E0

Initialize the floppy controller in the super I/O. Some interrupt vectors are

 

initialized. DMA controller is initialized. 8259 interrupt controller is

 

initialized. L1 cache is enabled.

 

 

E9

Set up floppy controller and data. Attempt to read from floppy.

 

 

EA

Enable ATAPI hardware. Attempt to read from ARMD and ATAPI CDROM.

 

 

EB

Disable ATAPI hardware. Jump back to checkpoint E9.

 

 

EF

Read error occurred on media. Jump back to checkpoint EB.

 

 

E9 or

Determine information about root directory of recovery media.

EA

 

 

 

F0

Search for pre-defined recovery file name in root directory.

 

 

F1

Recovery file not found.

 

 

F2

Start reading FAT table and analyze FAT to find the clusters occupied by the

 

recovery file.

 

 

F3

Start reading the recovery file cluster by cluster.

 

 

F5

Disable L1 cache.

 

 

FA

Check the validity of the recovery file configuration to the current

 

configuration of the flash part.

 

 

FB

Make flash write-enabled through chipset and OEM-specific method.

 

Detect correct flash part. Verify that the found flash part size equals the

 

recovery file size.

 

 

F4

The recovery file size does not equal the found flash part size.

 

 

FC

Erase the flash part.

 

 

FD

Program the flash part.

FFThe flash has been updated successfully. Make flash write-disabled. Disable ATAPI hardware. Restore CPUID value back into register. Give control to F000 ROM at F000:FFF0h.

87