Unit beeps
•Place the handset in the cradle for 20 seconds. If it still beeps, charge battery for 16 hours.
•Clean charging contacts on cordless handset and base/charge cradle with a soft cloth or an eraser.
•See solutions for “No dial tone.”
•Replace the battery.
Memory Dialing doesn't work
•Did you program the memory correctly?
•Did you follow proper dialing sequence? Unit shows SEARCHING or OUT OF RANGE
•Unplug the handset battery and plug it in again after 1 minute.
•Unplug the base power converter and plug it in again after 1 minute. Unit locks up and no communication between the base and cordless handset
•Unplug the power converter from the electrical outlet and the back of the base/charge cradle. Remove the handset battery. Wait for 30 seconds and plug the power converter back into the base/charge cradle and electrical outlet. Reconnect the battery and charge for 16 hours.
Cannot register extra handset 25802
•During registration, press and hold the page button of 25825 or 25826GE/GC until you hear a long beep. Then follow the steps listed in the handset registration section.
If no long beep is emitted, but the charge/in use indicator is blinking, the base is not in registration mode. It may be fully occupied with the maximum number of handsets (ie. 4). To register a new handset, you need to do a global
57