GE 60-883-95R Entering Program Mode, Setting the Clock, Changing an Access Code

Entering Program Mode

1.Open the panel cover by lifting on the tab at the top of the panel.

2.Enter Utility Access Code 1 or 2 using the num- bered keys.

The panel is now in program mode. Follow the pro- gramming arrows on the panel overlay. The system prompts you through programming steps with beeps and voice messages.

Tab

Figure 3. Cover Tab Location

Note

Do not remove panel power while in program mode. Pro- gramming changes are saved only when exiting pro- gram mode (closing the cover).

Setting the Clock

¾To set the clock:

1.Press Clock Set from the Start Menu. (The system will announce the programmed time and say “To change, press Hours and Minutes, then press Done.”)

Note

If 6 seconds passes without a key press the panel will announce the time and say “Time is x:xx A.M./ P.M., press hours and minutes, then press done or press cancel to quit.”

2.Press the Hours + and - buttons and listen to the voice prompts. Stop when panel voice announces the correct hour.

3.Press the Minutes + and - buttons and listen to the voice prompts. Stop when the panel announces the correct minutes.

4.Press Done. The panel announces the set time.

Changing an Access Code

¾To change an Access Code:

1. Enter Program Mode.

2. Verify the Access Code Length (Option 28).

3. Press the Add button from the Start Menu.

4.Press the Access Code button until you hear the name of the Access Code you want to change.

5.Press the Done button to select the Access Code.

6.Using the numbered keys, enter the new access code. The panel will repeat the Access Code after the last digit is entered.

ŠPressing the Cancel button after entering an access code will not revert to the old access code. Go through the steps again if you make a mistake.

I N S T R U C T I O N S Add Option

Option #1: Panel Voice Enable

Option #2: Account No.

Option #3: Phone No.

See Note

Press and follow

Add Option #

voice prompts.

Add Access Code

See Note

Press , then

Add Access Code DONE

use red numbers to enter access code.

Set Clock

See Note

Press

Clock Set Hours Minutes DONE

Delete

To delete an option or access code

press and follow voice prompts.

Delete

START MENU			Rev C
			422-3013
Clock Set
	1	+
			6
	2	Hours	+
Add		-
			Minutes
			7
			-
	3
Delete			8
			DONE
	4
	Access Code
			9
	5
Test	*Sensor		Cancel
			0

Cancel		MAIN MENU	*	Note:
If you make a mistake or want to start
			Option #	Hold key or press repeatedly
over press
	* Press for program information.			until you hear the desired item.
Cancel

Figure 4. Programming Overlay

Programming 6