Note
The sensor number can be changed during program mode by pressing the num- bered keys after pressing the sensor button. Sensors can be numbered 01 to 24. Be sure to enter 0 before the number for sensor numbers 1 to 9. The sensor number cannot be changed after it has been programmed.
To Add or Replace a Sensor using the Programming Buttons under the Panel Cover
1.Open the front cover.
2.Enter the Utility 1 or Utility 2 Access Code.
3.Press the Add button from the Start menu. The panel announces “Select from Main Menu.”
4.Press Sensor from the Main Menu.
The panel will announce “Press button on sensor X.” X is the next available sensor number. If 24 sensors are already programmed into the panel the panel says “Invalid.
5.Trip the sensor.
See Table 8 for descriptions of how to trip each type of sensor. The panel will announce “Press status to accept sensor.” DO NOT press Status at this time. Move on to Step 6.
6.If necessary, change the Sensor name by pressing the Option # button. See Table 8 for Sensor Type Options.
7.Press the Done button to program the sensor.
The system will announce the sensor name, type and number.
Table 8: Programming Sensors
Sensor Type | To Trip | Sensor Type Options |
|
|
|
|
|
|
Personal Help Button | Press the help button on the sensor. | Emergency Sensor Type Not Supervised |
|
| Emergency Sensor type Supervised |
|
|
|
Pendant Help Button | Press the help button on the sensor. | Emergency Sensor Type Not Supervised |
|
| Emergency Sensor type Supervised |
|
|
|
Door/Window Sensor | With the Door/Window Sensor cover | Activity Sensor type Supervised |
| removed, press the Program button on | Activity Sensor type Not Supervised |
| the top of the sensor. |
|
|
|
|
Freeze Sensor | With the Freeze Sensor cover | Freeze Sensor type Supervised |
| removed, press the Program button on |
|
| the top of the sensor. |
|
|
|
|
Water Sensor | With the Water Sensor cover | Water Sensor type Supervised |
| removed, press the Program button on |
|
| the top of the sensor. |
|
|
|
|
Smoke Alarm | Remove the base of the Smoke Alarm | Smoke Sensor type Supervised |
|
|
|
Carbon Monoxide (CO) | Plug in the CO Alarm. Within 60 sec- | Carbon Monoxide Sensor type Supervised |
Alarm | onds of plugging in, press and hold the |
|
| Test/Reset button until you hear 6 |
|
| beeps. |
|
|
|
|
Motion Sensor | Remove the sensor from its mounting | Activity Sensor type Supervised |
| plate. | Activity Sensor type Not Supervised |
|
|
|
Repeater | With the Repeater cover removed, | Repeater module type Supervised |
| press the tamper switch spring on the |
|
| circuit board. |
|
|
|
|
Adding/Replacing Sensors | 22 |
