| GEAppliances.com |
Controls–Dip Switches
The dip switch controls are located behind the front case panel, through an opening on the front of the unit.
To access the dip switches, remove the front case panel by removing the filter, taking out the four front screws, the upper two screws from the top of the panel and the shipping screws on each side, if present. (Discard the four side shipping screws, if present).
Safety Instructions
Operating
Side shipping screw
NOTE: The owner is responsible for setting the appropriate dip switches and connecting terminals.
Side shipping screw
Instructions
TL3 (C) (Temp. Limit
TL2 (C) (Temp. Limit
TL1 (C) (Temp. Limit
ALL I2R (All Electric Heat)
CONST FAN (Constant ON Fan)
TL1 (H) (Temp. Limit
TL2 (H) (Temp. Limit
TL3 (H) (Temp. Limit
No Function (Reserved for future use)
DUCT (Blower Fan)
OCCUPIED (Occupancy Sensor)
Care and Cleaning
Troubleshooting
All Electric Heat (Heat pump models only)
When this switch is enabled (UP), heat pump operation is locked out, causing the unit to provide only electric resistance heat.
ALL I2R (All Electric Heat)
Tips
Consumer Support
3