GE DVMRe user manual Power-Up

RS232 Port 1

For a Modem connection or remote control of unit. See section 3.17 for information about configuring the modem settings in the menu system. See section 9 for RS232 Remote Control Protocols.

DB-9 Pin Configuration For Port 1

Pin Use

1DCD

2RX

3TX

Pin Use

4DTR

5Ground

6Not Connected

Pin Use

7RTS

8CTS

9Not Connected

1 5

6 9

DB-9 on back panel.

RS232 Port 2

For Event Generation and ASCII Text Insertion.

RJ-45 Pin Configuration For RS232 Port 2

Pin	Use		Pin	Use
						1 2 3 4 5 6 7 8
1	Ground	5		TXD
2	Reserved	6		Not Connected
3	Not Connected	7		Ground
4	RXD	8		Reserved	RJ-45 socket on
						back panel.

1.8 Power-Up

It is important that the power-up procedures be followed carefully. The unit uses its auto-detect feature to detect camera signals during power-up, and configure itself automatically.

Power-up procedure

Once the system installation is complete, apply power in the following order:

1.Energize the monitors and all of the cameras.

2.Energize the DVMRe Triplex.

Power Supply Input

Voltage: 12 Volt DC

Power: 60 Watt (5 Amp)

Connector: 2.1mm barrel, center positive

Once power is applied to the unit, it will begin its power-up procedure. The unit will begin by displaying the software version on Monitor-A, then the unit will begin recording automatically.

Check Video Input Quality

Check the picture quality by selecting each camera for full screen display. If the picture quality is poor, check the following items:

∙The BNC connections.

∙The loop-through terminations.

∙The video levels of incoming signals.

∙The possibility of ground loops.

∙Consult the camera’s installation instructions for additional information about proper camera setup.

0150-0193F 16 Kalatel DVMRe Triplex