qMain Menu → Alarms → Link To A Macro
Use this menu to link an alarm input to a macro. If a link is created, a macro will run each time that alarm is activated.
Alarm: Select the alarm input you would like to link.
Macro: Select the macro number you wish to link to. Leave this setting blank if you do not wish to link to a macro.
Rotate the Jog to navigate, and the Shuttle to change the values.
Save changes and exit the menu: Select [OK], then press the Enter button.
Exit the menu without making changes: Press the Menu button, or select [CANCEL], then press the Enter button.
qMain Menu → Alarms → Fullscreen Alarm
Selecting Yes from this menu will cause the unit to always display the alarm camera fullscreen.
Selecting No from this menu will cause the unit to display the
Fullscreen Alarm
Fullscreen
NO
This menu selection is not available on
q Main Menu → Alarms → Relay Configuration
Use this menu to configure each relay output as either:
Relay Configuration
∙ Normally Open
Relay 01: N/OPEN
Relay 02: N/CLOSED
∙ Normally Closed
[CANCEL] [OK]
qMain Menu → Alarms → Buzzer Setup
Use this menu to configure the internal buzzer.
Global Buzzer: The Global Buzzer setting acts as a master On/Off switch. Setting the Global Buzzer to OFF deactivates all buzzer activity.
Live Alarm Buzzer: Activates while receiving alarm input.
Videoloss Buzzer: Activates when video loss is detected.
Disabling the Videoloss buzzer disables all videoloss buzzer activity. Videoloss buzzers may be disabled on a per camera basis in the Alarms → Videoloss Action menu.
Playback Buzzer: Activates during playback of recorded alarms.
Buzzer Setup
Global Buzzer | : ON |
Live Alarm Buzzer: ON | |
Videoloss Buzzer | : ON |
Playback Buzzer | : ON |
[CANCEL] [OK]
44 | Kalatel DVMRe Triplex |
