GE DVMRe user manual Motion Detection, Main Menu → Macro → Edit Submacro, Running a Macro

qMain Menu → Macro → Edit Submacro

A submacro is an RS232 command string that is used to control a peripheral device. Submacros are activated during macros. See the table above for information about programming a macro to activate a submacro.

Select the submacro you wish to edit from the menu system. This menu will appear.

Edit Submacro 01

080 066 066 010 --- --- --- --- --- ---

[P] [B] [B] [0]

[CANCEL] [OK]

ENTER key starts Submacro edit

Use this menu to create the RS232 command string. Press the Enter button to Enter and Exit the submacro edit mode. Rotate the Jog/Shuttle to navigate among the fields and change the values. Each byte value can be set from 0 to 255.

Running A Macro

A macro is a recorded sequence of up to 32 keystrokes. To activate a macro, press the Function button followed by the Number button of the desired macro. While running, the macro is indicated on-screen as the letter F and the macro number.

The user can cancel the macro at any time by pressing the Function button.

{F} 1

Function and

Number Buttons

Daylight Savings Time (Alternate Method)

To adjust the time one hour for daylight savings time, press the Function button, then the Sequence button. If this function is activated during April, one hour is added to the time. If this function is activated in October, one hour is subtracted from the time. This function will only operate once per time period.

{F}

Function and

Sequence Buttons

3.13 Motion Detection

Use this menu to:

∙Enable motion detection on a per camera basis.

∙Activate individual zones in a scene to respond to motion detection.

∙Activate the on-screen motion detection indicator.

∙Set motion detection as Activity detection or Intrusion Detection.

∙Configure the motion detection parameters on a per camera basis.

Enable/Disable Detection

Setup Parameters

Setup Active Zones

Indicate Detection

0150-0193F 49 Kalatel DVMRe Triplex