Safety Rules
It.. SAVE THESE INSTRUCTIONS - The manufacturer suggests that these rules for safe operation be
... copied and posted In potential hazard areas. Safety should be stressed to all operators, potential operators, and service and repair technicians for this equipment.
It.. SAVE THESE INSTRUCTIONS - This manual contains Important Instructions that should be followed "'durlngInstallation and maintenance of the generator and batteries.
Study these SAFETY RULES carefully before installing, operating or servicing this equipment. Become familiar with this Owner's Manual and with the unit. The generator can operate safely, effi- ciently and reliably only if it is properly installed, operated and maintained. Many accidents are caused by failing to follow simple and fundamental rules or precautions.
The manufacturer cannot anticipate every possible circumstance
that might involve a hazard. The warnings in this and on tags and decals affixed to the unit are, therefore, not
~
It.. Despite the safe design of this genera·
... tor, operating this equipment Imprudently, neglecting Its maintenance or being careless can cause possible Injury or death. Permit only responsible and capable persons to Install, operate or maintain this equipment.
~Potentially lethal voltages are generated by ~these machines. Ensure all steps are taken to
render the machine safe before attempting to work on the generator.
It.. Parts of the generator are rotating and/or hot
... during operation. Exercise care near running generators.
GENERAL HAZARDS
•For safety reasons, the manufacturer recommends that this equipment be installed, serviced and repaired by an Authorized Service Dealer or other competent, qualified electrician or installation technician who is familiar with applicable codes, standards and regulations. The operator also must comply with all such codes, standards and regulations.
• Installation, operation, servicing and of this (and related) equipment must always comply with applicable codes, stan- dards, laws and regulat'lons.Adhere strictly to local, state and national electrical and building codes. Comply with regulations the Occupational Safety and Health Administration (OSHA) has established. Also, ensure that the generator is installed, operat- ed and serviced in accordance with the manufacturer'sinstruc- tions and recommendations. Following installation, do nothing that might render the unit unsafe or in noncompliance with the aforementioned codes, standards, laws and regulations.
•The engine exhaust fumes contain carbon monoxide gas, which can be DEADLY. This dangerous gas, if breathed in sufficient concentrations, can cause unconsciousness or even death. For that reason, adequate ventilation must be provided. Exhaust gases must be piped safely away from any building or enclosure that houses the generator to an area where people, animals, etc., will not be harmed. This exhaust system must be installed properly, in strict compliance with applicable codes and standards.
•Keep hands, feet, clothing, etc, away from drive belts, fans, and other moving or hot parts. Never remove any drive belt or fan guard while the unit is operating.
•Adequate, unobstructed flow of cooling and ventilating air is critical in any room or building housing the generator to prevent buildup of explosive gases and to ensure correct generator operation. Do not alter the installation or permit even partial blockage of ventilation provisions, as this can seriously affect safe operation of the generator.
•Keep the area around the generator clean and uncluttered. Remove any materials that could become hazardous.
•When working on this equipment, remain alert at all times. Never work on the equipment when physically or mentally fatigued.
•Inspect the generator regularly, and promptly repair or replace all worn, damaged or defective parts using only factory- approved parts.
•Before performing any maintenance on the generator, discon-
nect its battery cables to prevent accidental
•Never use the generator or any of its parts as a step. Stepping on the unit can stress and break parts, and may result in dan- gerous operating conditions from leaking exhaust gases, fuel leakage, oil leakage, etc.
2
