Gigabyte AGP 4X(1.5V) manual Fpanel 2x10 pins connector

11) F_PANEL (2x10 pins connector)

Please connect the power LED, PC peaker, reset switch and power switch etc of your chassis front panel to the F_PANEL connector according to the pin assignment above.

Soft Power

English

Message LED/Power/ Sleep LED

Connector

Speaker Connector

	MPD-							PW-
						PW+
	MPD+	2		1			1
			1					1
		1
		HD+
IDE Hard Disk
		HD-							NC
Active LED
					RSE-
							RSE+

SPK+ SPK-

1 20

19

	Reset Switch
HD (IDE Hard Disk Active LED)	Pin 1: LED anode(+)
(Blue)	Pin 2: LED cathode(-)
SPK (Speaker Connector)	Pin 1: VCC(+)
(Amber)	Pin 2- Pin 3: NC
	Pin 4: Data(-)
RES (Reset Switch)	Open: Normal Operation
(Green)	Close: Reset Hardware System
PW (Soft Power Connector)	Open: Normal Operation
(Red)	Close: Power On/Off
MSG(Message LED/Power/	Pin 1: LED anode(+)
Sleep LED)(Yellow)	Pin 2: LED cathode(-)
NC( Purple)	NC

12) RAM_LED

Do not remove memory modules while DIMM LED is on. It might cause short or other unexpected damages due to the 2.5V stand by voltage. Remove memory modules only when AC Power cord is disconnected.

+ -

- 25 - Hardware Installation Process