USB Controller
Enables or disables the integrated USB controller. (Default: Enabled)
Disabled will turn off all of the USB functionalities below.
USB 2.0 Controller
Enables or disables the integrated USB 2.0 controller. (Default: Enabled)
USB Keyboard Support
Allows USB keyboard to be used in
USB Mouse Support
Allows USB mouse to be used in
Legacy USB storage detect
Determines whether to detect USB storage devices, including USB flash drives and USB hard drives during the POST. (Default: Enabled)
Azalia Codec
Enables or disables the onboard audio function. (Default: Auto)
If you wish to install a 3rd party
Onboard H/W LAN
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party
Green LAN
When the onboard LAN function and Green LAN if LAN cable(s) is connected or not. If not, the automatically. (Default: Disabled)
are enabed, the system will dynamically detects corresponding LAN controller will be disabled
SMART LAN (LAN Cable Diagnostic Function)
CMOS Setup
SMART LAN
Start detecting at Port |
|
|
|
|
|
| Item Help | ||
= | Open | / | Length | = | 0m |
| Menu Level | ||
= | Open | / | Length | = | 0m |
|
|
| |
= | Open | / | Length | = | 0m |
|
|
| |
= | Open | / | Length | = | 0m |
|
|
| |
: Move | Enter: Select |
| F10: Save | ESC: Exit | F1: General Help | ||||
F5: Previous Values |
| F6: |
| F7: Optimized Defaults | |||||
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN cable. This feature will detect cabling issue and report the approximate distance to the fault or short. Refer to the following information for diagnosing your LAN cable:
When No LAN Cable Is Attached...
If no LAN cable is attached to the motherboard, the Status fields of all four pairs of wires will show Open and the Length fields show 0m, as shown in the figure above.
- 51 - | BIOS Setup |
