Manuals / Gigabyte / Computer Equipment / Computer Hardware

Gigabyte GA-EP45-UD3LR user manual Onboard LAN Boot ROM, Onboard IDE Controller JMicron 368 Chip

Models: GA-EP45-UD3L GA-EP45-UD3LR

1 112

Download 112 pages 29.49 Kb

Page 52

When LAN Cable Is Functioning Normally...

When LAN Cable Is Functioning Normally...

If no cable problem is detected on the LAN cable connected to a Gigabit hub or a 10/100 Mbps hub, the following message will appear:

Start detecting at Port.....

Link Detected --> 100Mbps

Cable Length= 30m

Link Detected	Displays transmission speed
Cable Length	Displays the approximate length of the attached LAN cable.

Note: The Gigabit hub will only operate at a speed of 10/100 Mbps in MS-DOS mode; it will operate at a normal speed of 10/100/1000 Mbps in Windows mode or when the LAN Boot ROM is activated.

When a Cable Problem Occurs...

If a cable problem occurs on a specified pair of wires, the Status field will show Short and then length shown will be the approximate distance to the fault or short.

Example: Part1-2 Status = Short / Length = 2m

Explanation: A fault or short might occur at about 2m on Part 1-2.

Note: Part 4-5 and Part 7-8 are not used in a 10/100 Mbps environment, so their Status fields will show Open, and the length shown is the approximate length of the attached LAN cable.

Onboard LAN Boot ROM

Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip. (Default: Disabled)

Onboard IDE Controller (JMicron 368 Chip)

Enables or disables the IDE controller integrated in the JMicron 368 chip. (Default: Enabled)

Onboard Serial Port 1

Enables or disables the first serial port and specifies its base I/O address and corresponding interrupt. Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.

Onboard Parallel Port

Enables or disables the onboard parallel port (LPT) and specifies its base I/O address and corresponding interrupt. Options are: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.

Parallel Port Mode

Selects an operating mode for the onboard parallel (LPT) port. Options are: SPP (Standard Parallel Port)(default), EPP (Enhanced Parallel Port), ECP (Extended Capabilities Port), ECP+EPP.

GA-EP45-UD3LR/UD3L Motherboard

- 52 -

Image 52

Gigabyte GA-EP45-UD3LR user manual Onboard LAN Boot ROM, Onboard IDE Controller JMicron 368 Chip, Onboard Serial Port

Contents

GA-EP45-UD3LR/ GA-EP45-UD3L Users ManualMotherboard GA-EP45-UD3LR GA-EP45-UD3L Oct. 8Motherboard GA-EP45-UD3LR/GA-EP45-UD3LCopyright DisclaimerDocumentation Classifications Identifying Your Motherboard RevisionTable of Contents GA-EP45-UD3LR/GA-EP45-UD3L Motherboard Layout1-3-1 1-4-1Chapter 3 Drivers Installation Chapter 4 Unique FeaturesConfiguring SATA Hard Drives Chapter 5 AppendixBox Contents Optional ItemsGA-EP45-UD3LR/GA-EP45-UD3L GA-EP45-UD3LR/GA-EP45-UD3L Motherboard Layout4 PCI Express Block DiagramLPC Bus Chapter 1 Hardware Installation 1-1 Installation PrecautionsProduct Specifications The PCI Express x16 slot conforms to PCI Express 2.0 standardInternal Connectors Page 1-3 Installing the CPU and CPU Cooler 1-3-1 Installing the CPUCPU Socket Lever Direction of the Arrow Sign on the Male Push Pin 1-3-2 Installing the CPU CoolerMale Push Pin The Top of Female Push Pin Female Push Pin 1-4 Installing the Memory 1-4-1 Dual Channel Memory Configuration1-4-2 Installing a Memory 1-5 Installing an Expansion Card PCI Express x1 Slot PCI Express x16 Slot PCI Slot1-6 Back Panel Connectors Optical S/PDIF Out ConnectorCoaxial S/PDIF Out Connector PS/2 Keyboard and PS/2 Mouse PortCenter/Subwoofer Speaker Out Jack Orange Rear Speaker Out Jack BlackSide Speaker Out Jack Gray Line In Jack Blue1-7 Internal Connectors PHASE LEDATX12V CDIN1/2 ATX12V/ATX 2x2 12V Power Connector and 2x12 Main Power Connector +5V Only for 2x12-pinATX3/4/5 CPUFAN/SYSFAN1/SYSFAN2/PWRFAN Fan Headers 6 FDD Floppy Disk Drive Connectorheaders 7 IDE IDE Connector 8 SATA20/1/2/3/4/5 SATA 3Gb/s ConnectorsSATA20 SATA248 SATA20/1/2/3/4/5 SATA 3Gb/s Connectors 9 PWRLED System Power LED HeaderOnly for GA-EP45-UD3L 10 FAUDIO Front Panel Audio Header 11 FPANEL Front Panel Header 12 CDIN CD In Connector, Black 13 SPDIFI S/PDIF In Header, Red15 FUSB1/FUSB2 USB Headers, Yellow 14 SPDIFO S/PDIF Out HeaderDo not plug the IEEE 1394 bracket 2x5-pin cable into the USB header 16 LPT Parallel Port Header 17 COMA Serial Port Header, White18 CI Chassis Intrusion Header 19 CLRCMOS Clearing CMOS Jumper20 BAT BATTERY 21 PHASE LEDYou may clear the CMOS values by removing the battery 1. Turn off your computer and unplug the power cordChapter 2 BIOS Setup A. The LOGO Screen Default 2-1 Startup ScreenB. The POST Screen DEL BIOS SETUP\Q-FLASHSample BIOS Version GA-EP45-UD3L E19 BIOS Setup Program Function Keys2-2 The Main Menu Main Menu Help Standard CMOS Features  Advanced BIOS Features Power Management Setup  PnP/PCI Configurations2-3 MB Intelligent TweakerM.I.T Clock Chip ControlDRAM Performance Control Mother Board Voltage ControlRobust Graphics Booster CPU Clock Ratio NoteFine CPU Clock Ratio Note CPU FrequencyCPU Host Frequency Mhz PCI Express Frequency MhzC.I.A.2 Advanced Clok ControlCPU Clock Drive PCI Express Clock DriveCPU Clock Skew MCH Clock SkewCommand RateCMD CAS Latency TimetRCD tRASChannel A/B Timing Settings tRD Phase0 AdjustmenttRD Phase1 Adjustment tRD Phase2 AdjustmentChannel A/B Driving Settings DDR Write TrainingDriving Strength Profile Data Driving Pull-Up LevelLoad-Line Calibration CPU VcoreCPU Termination CPU PLLStandard CMOS Features DateTime IDE Channel 0, 1 Master/SlaveFloppy 3 Mode Support IDE Channel 2, 3 Master, IDE Channel 4 Master/SlaveDrive A Halt OnAdvanced BIOS Features Hard Disk Boot PriorityFirst/Second/Third Boot Device Password CheckCPU Multi-Threading Note Limit CPUID Max. to 3 NoteNo-Execute Memory Protect Note CPU Enhanced Halt C1ENoteFull Screen LOGO Show Delay For HDD SecsInit Display First Integrated Peripherals SATA RAID/AHCI Mode Intel ICH10R SouthbridgeDisabled Enables RAID for the SATA controllersSMART LAN LAN Cable Diagnostic Function USB ControllerUSB 2.0 Controller USB Keyboard SupportOnboard LAN Boot ROM Parallel Port ModeOnboard IDE Controller JMicron 368 Chip Onboard Serial PortPower Management Setup Power On by RingSoft-Off by PWR-BTTN PME Event Wake UpResume by Alarm HPET Mode NotePower On By Mouse Power On By Keyboard2-8 PnP/PCI Configurations PCI1 IRQ AssignmentPCI2 IRQ Assignment BIOS auto-assigns IRQ to the first PCI slot. DefaultReset Case Open Status Current System/CPU TemperatureCurrent CPU/SYSTEM/POWER FAN Speed RPM CPU Warning TemperatureCPU Smart FAN Mode CPU Smart FAN Control2-11 Load Optimized Defaults 2-10 Load Fail-Safe DefaultsLoad Optimized DefaultsSaveY/N?& ExitN Setup Set Supervisor/User Password 2-12Supervisor Password User Password2-13 Save & Exit Setup 2-14 Exit Without SavingChapter 3 Drivers Installation 3-1 Installing Chipset Drivers3-2 Application Software 3-3 Technical Manuals3-4 Contact 3-5 SystemDrivers Installation This page provides the basic system information3-6 Download Center Chapter 4 Unique Features 4-1 Xpress Recovery2Before You Begin System RequirementsInstallation and Configuration A. Installing Windows XP and Partitioning the Hard Drive4. After the operating system is installed, right-click the My Computer icon on your desktop and select Manage Figure 4. Go to Computer Management to check disk allocation. Xpress Recovery2 will save the backup file to the unallocated space black stripe along the topFigure 5. Please note that if there is no enough unallocated space, Xpress Recovery2 cannot save the backup file B. Accessing Xpress Recovery2 C. Using the Backup Function in Xpress Recovery2E. Removing the Backup D. Using the Restore Function in Xpress Recovery2F. Exiting Xpress Recovery2 4-2 BIOS Update Utilities 4-2-1 Updating the BIOS with the Q-Flash UtilityA. Before You Begin What is DualBIOSTM?Copy BIOS completed - Pass B. Updating the BIOSPlease press any key to continue Load Optimized DefaultsSaveY/N?& ExitY Setup 4-2-2 Updating the BIOS with the @BIOS Utility B. Using @BIOSC. After Updating the BIOS 1. Update the BIOS Using the Internet Update Function4-3 EasyTune The EasyTune 6 Interface Tabs InformationMeter Mode - Button Information Table The Dynamic Energy Saver Advanced Interface A. Meter Mode4-4 Dynamic Energy Saver Advanced Total Mode - Button Information Table B. Total ModeC. Stealth Mode 4-5 Q-Share Directions for using Q-ShareOptions Descriptions 4-6 Time Repair System RestorePreference Screen 5-1 Configuring SATA Hard Drives 5-1-1 Configuring the Onboard SATA ControllerTo configure SATA hard drives, follow the steps below A. Installing SATA hard drives in your computerB. Configuring SATA controller mode in BIOS Setup C. Configuring a RAID array in RAID BIOS Create RAID VolumeStep StepGA-EP45-UD3LR/UD3L Motherboard WARNING ALL DATA ON SELECTED DISKS WILL BE LOST Delete RAID Volume DELETE VOLUME VERIFICATION ALL DATA IN THE VOLUME WILL BE LOSTRequired for AHCI and RAID Mode 5-1-2 Making a SATA RAID/AHCI Driver DiskettePage 5-1-3 Installing the SATA RAID/AHCI Driver and Operating System A. Installing Windows XPPage WindowsXP Professional Setup Welcome to Setup B. Installing Windows Vista Step Configuring Audio Input and Output Configuring 2/4/5.1/7.1-Channel AudioA. Configuring Speakers 5-2-1C. Activating an AC97 Front Panel Audio Module B. Configuring Sound EffectD. Muting the Back Panel Audio For HD Audio Only A. Installing the S/PDIF In Cable 5-2-2 Installing the S/PDIF In Cable OptionalS/PDIF In S/PDIF Out C. Configuring S/PDIF outB. Conneting a S/PDIF out Cable 5-2-3 Configuring Microphone Recording Select Realtek HD Audio Input in the Mixer device list Recording the Sound 5-2-4 Using the Sound RecorderPlaying the Sound 5-3 Troubleshooting 5-3-1 Frequently Asked Questions5-3-2 Troubleshooting Procedure Correctly insert theThe power supply device, connectormonitor might fail CPU or CPU socketWEEE Symbol Statement 5-4 Regulatory StatementsRegulatory Notices Our Commitment to Preserving the EnvironmentChina Restriction of Hazardous Substances Table GA-EP45-UD3LR/UD3L Motherboard Appendix GA-EP45-UD3LR/UD3L Motherboard Appendix GA-EP45-UD3LR/UD3L Motherboard Appendix GA-EP45-UD3LR/UD3L Motherboard Contact Us  GIGABYTE Global Service System