Follow these instructions to connect a Cable

Box to your DVD+VCR.

Cable Box

From Cable

Wall Outlet

Input Output

TV

VHF/UHF

1 C O N N E C T C A B L E T O

6 S E T D V D + V C R O U T P U T

C A B L E B O X

C H A N N E L

C A B L E B O X H O O K U P

Connect an RF coaxial cable from your cable wall outlet to the Input jack on the Cable Box.

2C O N N E C T C A B L E B O X T O D V D + V C R

Connect a second RF coaxial cable from the Output jack on the Cable Box to the ÒIN (FROM ANT.)Ó jack on the back panel of the DVD+VCR.

3C O N N E C T D V D + V C R T O T V

Connect the supplied RF coaxial cable from the ÒOUT (TO TV)Ó jack on the back panel of the DVD+VCR to your televisionÕs ÒAntenna InÓ jack.

4P L U G I N D V D + V C R

Connect the DVD+VCR power cord to a standard 120V/60Hz wall outlet.

5 T U R N O N D V D + V C R , T V &

C A B L E B O X

Set the CH (channel) switch on the back panel of the DVD+VCR to 3 or 4, whichever is NOT used by your cable box.

7 T U N E T V T O T H E S A M E C H A N N E L

Tune your TV to the same channel you selected in step 6.

8C O N N E C T I O N I S C O M P L E T E !

The ÒLanguage/Langue/IdiomaÓ menu will appear on your television screen. Please proceed with Auto Setup on page 3.

¥Use your cable box to select channels.

¥If you are not getting a good picture, repeat steps 6 and 7 using the other channel; i.e., try channel 4 instead of channel 3.

Press POWER on the DVD+VCR, TV, and Cable Box.

Appendix A - Advanced Connections

41

Page 47
Image 47
Go-Video DVR 4550 manual B L E B O X H O O K U P, B L E B O A N N E L