2000 Autoflow
INSTALLATION
Storage Chamber High Limit Rotary Switch Installation
1)Drill a 2” diameter hole through the sidewall 3’ below the fan/heater.
2)If the bin is 2.66” corrugation the hole should be centered on an outside hill.
3)If the bin is 4.00” corrugation the hole should be centered on an outside valley.
4)Use the mounting plate as a pattern and drill four 3/8” holes through the sidewall at the switch location so the plate can be bolted to the bin.
5)Add foam weather strip around the top and side of the mounting plate.
6)Caulk the underside of the mounting plate, on all sides of the 2” hole, and
where the plate meets the bin.
7)Bolt the mounting plate to the sidewall.
8)Attach the flex coupling to the rotary switch power pack using a roll pin.
9)Attach the
10)Apply teflon tape or pipe sealant (not included) to the rotary switch power pak threads and thread the rotary switch power pack into the mounting plate coupling.
11)Make sure that the conduit hole is facing down or is horizontal.
Storage chamber rotary switch.
23
