Extreme Networks 12800 Series manual BlackDiamond Series Blank Front Panels

Installing Modules and Connecting Cables

3Squeeze the release latch on each injector/ejector handle and rotate both handles outward to disconnect the module from the chassis backplane (see Figure 68).

CAUTION

To prevent ESD damage, hold the module by the metal panel edges only. Never touch the components on the PCB or the pins on any of the connectors.

4Slide the module out of the chassis slot.

5Place the module into the anti-static bag to protect it from potential ESD damage. The bag will also prevent dust from collecting on the module connectors.

6If you are not going to install a replacement module, install a blank front panel. To install a replacement module, follow the installation procedure starting on page 102.

NOTE

Leave the ESD-preventive wrist strap permanently connected to the chassis so that it is always available when you need to touch ESD-sensitive components.

BlackDiamond Series Blank Front Panels

BlackDiamond switches are shipped with blank front panels installed over one or more chassis slots. You can remove or install a blank front panel at any time without disrupting network services. Complete the action of installing a blank front panel in a reasonable time-frame to avoid disruption to adequate airflow.

CAUTION

All unoccupied slots in a BlackDiamond 12800 series switch must have blank front panels correctly installed to ensure conformance to FCC requirements as well as to maintain adequate airflow through the switch.

You need the following tools and equipment to install or remove a blank front panel:

●ESD-preventive wrist strap

●#2 Phillips screwdriver

Installing a Blank Front Panel

To install the blank front panel:

1Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground receptacle on the BlackDiamond chassis.

On a BlackDiamond 12804 chassis, the ground receptacle is at the top left corner. On a BlackDiamond 12802 chassis, the ground receptacle is at the top right corner.

2Align the blank front panel over the open slot on the chassis (see Figure 69).

Make sure that the EMI gasket is on the top of the panel and the stenciled part number is right side up.

108 BlackDiamond 12800 Series Switches Hardware Installation Guide