Replacing AC Power Supply Cords
The power supply bay can accommodate up to three
NOTE
The Extreme Networks 325 W AC PSU cannot be used in combination with any other Extreme Networks PSU.
The 325 W AC PSU functions from 90 V to 264 V and 47 Hz to 63 Hz AC Input. The software determines the maximum available power required for the switch and enables the modules accordingly.
LEDs
The front panel of the Extreme Networks 325 W AC PSU provides status LEDs. Table 13 describes the meanings of these LEDs.
Table 13: LEDs on the 325 W AC PSU
PSU Condition | AC In | DC Out |
LED Status | LED Status | |
|
|
|
No AC input power | Off | Off |
No AC input power (receiving standby power from the chassis) | Amber | Off |
AC input good (main outputs disabled) | Green | Off |
AC input good, output fault | Green | Amber |
AC input good, DC output good | Green | Green |
|
|
|
Replacing AC Power Supply Cords
Each Extreme Networks 325 W AC PSU is shipped with a 110 V AC
All power supply cords provided by Extreme Networks are designed for use in the United States and Canada only. Power supply cords for use outside of North America are typically provided by a
●Power supply cords must be agency certified for country of use.
●Power supply cords must contain an IEC 320 C13 connector for insertion into the IEC 320 C14 receptacle on the PSU.
●Power supply cords must contain an appropriately rated and approved wall plug applicable to the country of installation.
●Power supply cords must be less than 5 m long.
●Wire size must be a minimum of 18 AWG (0.82 mm2)
WARNING!
Make sure that the source outlet is properly grounded before plugging the AC power cord into the Extreme Networks 325 W AC PSU.
BlackDiamond 12800 Series Switches Hardware Installation Guide | 37 |
|
|
