Extreme Networks 12800 Series manual Injector/Ejector Handles in the Latched Position

Installing Modules and Connecting Cables

Figure 64: Injector/Ejector Handles in the Latched Position

EX_124

CAUTION

There are two styles of ejector/injector handles on the BlackDiamond 12800 series modules. Pay careful attention to the instructions in the next step.

8Using a #2 Phillips screwdriver, lock the module into place in one of the following ways (Figure 65):

●If the captive screw on each handle has a yellow band around the head of the screw, turn the screw on each injector/ejector handle clockwise and completely down. When the screw is completely tightened, the yellow band around the captive screw is completely hidden.

CAUTION

Be careful to avoid over-torquing and stripping the screw heads.

●If the captive screw on each handle has a red line on the head (see Figure 66), turn each captive screw one-quarter turn (90 degrees) clockwise. When the module is correctly locked, the red line on the captive screw in each injector/ejector handle is in a vertical position.

CAUTION

Be sure to turn each captive screw only 90 degrees or one-quarter turn clockwise. Tightening the captive screws beyond 90 degrees will damage the injector/ejector handles on the modules.

Figure 65: Locking the Module into Place

EX_125

104 BlackDiamond 12800 Series Switches Hardware Installation Guide