Harman-Kardon AVR 147 Front Panel Controls, Headphone Jack $ Speaker/Channel Input Indicator

Front Panel Controls

ENGLISH

DIGITAL	LOGIC 7	VID 1	DVD
PRO LOGIC	DSP	VID 2	CD
3 STEREO		VID 3
HEADPHONE	SURR. OFF		TAPE

1 Main Power Switch	! Tuner Band Selector	Ô Video 3 input jacks
2 System Power Control	@ Set Button	 Input Indicators
3 Power Indicator	# Preset Stations Selector	Ò Main Information Display
4 Headphone Jack	$ Speaker/Channel Input Indicator	Ú Remote Sensor Window
5 Surround Mode Group Selector	% Input Source Selector	Û Digital Input Selector
6 Speaker Select Button	^ RDS Select Button	Ù Channel Select Button
7 Selector Buttons	& Delay	ı Volume Control
8 Tone Mode	* Digital Optical 3 Input
9 Surround Mode Selector	( Surround Mode Indicators
) Tuning	Ó Digital Coax 3 Input

1Main Power Switch: Press this button to apply power to the AVR. When the switch is pressed in, the unit is placed in a Standby mode, as indicated by the orange LED 3. This button MUST be pressed in to operate the unit. To turn the unit off completely and prevent the use of the remote control, this switch should be pressed until it pops out from the front panel so that the word “OFF” may be read at the top of the switch.

NOTE: This switch is normally left in the “ON” position.

2System Power Control: When the Main Power Switch 1 is “ON,” press this button to turn on the AVR; press it again to turn the unit off (to Standby). Note that the Power Indicator 3 will turn blue when the unit is on.

3Power Indicator: This LED will be illuminated in orange when the unit is in the Standby mode to signal that the unit is ready to be turned on. When the unit is in operation, the indicator will turn blue.

4Headphone Jack: This jack may be used to listen to the AVR’s output through a pair of head- phones. Be certain that the headphones have a standard 6.3 mm stereo phone plug. Note that the speakers will automatically be turned off when the headphones are connected.

When configuring your system using EzSet/EQ, the calibration microphone should be plugged into this jack 4 using the supplied adaptor that converts the small mini-plug at the end of the microphone’s cord to a 1/4" plug.

5Surround Mode Group Selector: Press this button to select the top-level group of surround modes. Each press of the button will select a major mode grouping in the following order:

Dolby Modes ➜ DTS Digital Modes ➜ DSP Modes ➜ Stereo Modes ➜ Logic 7 Modes

Once the button is pressed so that the name of the desired surround mode group appears in the Main Information Display Ò, press the Surround Mode Selector 9 to cycle through the individual modes available. For example, press this button to select Dolby modes, and then press the Surround Mode Selector 9 to choose from the various mode options.

6Speaker Select Button: Press this button to begin the process of selecting the speaker positions that are used in your listening room. (See page 17 for more information on setup and configuration.)

FRONT PANEL CONTROLS 5